Custom LED

BXSW-1

Custom LED Blaster-X Control Switch for Blaster-X Integrated Tail Lights

Tail Light Assemblies

Works with all Custom LED Blaster-X Tail Lights to control strobe mode and programming features.
Comes with 24" long 22AWG gray wire soldered to switch.
Comes with 16" long 22AWG black wire with ring terminal for ground connection.
NEW! Features an on-off-momentary operation for easy programming and strobe-mode use.

The Blaster-X Control Switch is an optional accessory for all Blaster-X Tail Lights. This switch will allow you to conveniently control the strobe mode operation of the tail light (intense strobe cycle, like hazards on steroids), and to program advanced features of the tail light. General Blaster-X Tail Light Programming instructions are available here. Check the instructions for your specific Blaster-X tail light for exact features.This switch is not necessary for standard integrated tail light operation.Each Blaster-X Control Switch comes with a 24" long gray wire to connect to the tail light gray wire (control/program wire), and a 16" long black wire with ring connector for ground connection at battery or anywhere on frame.

Custom LED Electronic LED Flasher Relay for LED Blinkers on Motorcycles - ELFR-1 QD
Custom LED Electronic LED Flasher Relay for LED Blinkers on Motorcycles - ELFR-1
2008-2014 Yamaha Raider Blaster-X Integrated LED Tail Light
2014-2016 Yamaha FZ-09 Blaster-X Integrated LED Tail Light
2002-2009 Yamaha Warrior Blaster-X Integrated LED Tail Light
Front Bumper Reinforcement : RL 96-98
General Motors Clip 16600277
Mix me 4837