Oil Drain Plugs ECO-PLUG 14MM-18MM1.25

ECO-PLUG

14MM-18MM1.25"

ECO-PLUG - Oil Drain Plug for DAMAGED Aluminum Oil Pan Thread Size 14mm-18mm Thread Diameter 1.25 Long Thread Drain Hole

EAN: 0696859960123

UPC: 696859960123

Oil Drain Plugs


The Revolutionary Threadless, Magnetic, Life Time, Leakproof, Oil Pansaver, Motor Oil Drain Plug.
Eco-Plug Hand Installs Magnetically In Seconds & Removes Safely With Vice Grips Or Our Exclusive Magnetic Removal Tool.
To Expedite Every Oil Change Service. The Future Of Motor Oil Drain Plugs Has Arrived!
Eco-Plug Is Guaranteed To Outperform Over Size / Butterfly / Threaded Drain Plugs / Helicoils / Timeserts / Quick Valves.
Stop Threading Drain Plugs That Damage Oil Pan Threads & Leak Oil. Go Threadless, Go Magnetic, Go Ecoplug

THE FUTURE OF MOTOR OIL DRAIN PLUGS HAS ARRIVED...

CHANGE YOUR MOTOR OIL MAGNETICALLY,  ELIMINATE EXPENSIVE MOTOR OIL PAN REPLACEMENT  IN SECONDS!

GO THREADLESS, GO MAGNETIC, GO ECOPLUG.

INSTALLATION INSTRUCTIONS:

1. (DRAIN OIL) HAND INSTALL SELF TAP TAPERED THREAD BOLT STRAIGHT INTO DAMAGED ALUMINUM OIL PAN THREADS. PUSH / TURN CLOCKWISE UNTIL THREADS TAKE HOLD.

2. APPLY 7/8” WRENCH TO HEX-BOLT SLOWLY TURN CLOCKWISE *NOTE* TAPERED THREAD INSTALLATION WILL VARY DUE TO VARIATIONS IN DRAIN HOLE DIAMETER. CONTINUE UNTIL THOROUGHLY TIGHT.

3. REMOVE HEX-BOLT / WIPE TAPERED THREADS CLEAN

4. KNEAD TWO COLOR EPOXY UNTIL UNIFORM COLOR. APPLY TO & AROUND MARRED AREA OF TAPERED THREADS.

5. WIPE DRAIN HOLE THREADS. REINSTALL TAPERED THREAD BOLT, WITH APPLIED EPOXY INTO DRAIN HOLE. WITH 7/8” WRENCH TURNING CLOCKWISE UNTIL THOROUGHLY TIGHT.

6. LET STAND 10 MINUTES. FILL WITH OIL. CHECK FOR LEAKS. IF LEAK IS PRESENT SLOWLY TURN HEX BOLT CLOCKWISE UNTIL LEAK STOPS.

REMOVAL INSTRUCTIONS:

1. (DO NOT REMOVE HEX-BOLT) APPLY MAGNETIC REMOVAL TOOL TO ECOPLUG STEEL PIN, OR GRIP WITH PLIERS. PULL TO REMOVE.

2. AT EACH OIL CHANGE SERVICE... INSPECT ECOPLUG RUBBER GASKET. WIPE RESIDUAL OIL FROM INSIDE HEX-BOLT & REINSTALL ECO-PLUG.



ECO-PLUG - Oil Drain Plug for DAMAGED Aluminum Oil Pan Tapered Thread Size 12mm-16mm Thread Diameter 1.25 Long Thread Recessed Drain Hole
ECO-PLUG - Oil Drain Plug for DAMAGED Aluminum Oil Pan Tapered Thread Size 12mm-16mm Thread Diameter 3/4 Short Thread Non-Recessed Drain Hole
J-B Weld 8297 HighHeat 550 Degree Epoxy Putty Stick - 2 oz.
Dorman 65200 AutoGrade Oil Drain Plug
ECO-PLUG - Oil Drain Plug for 10mm-14mm for DAMAGED or UNDAMAGED Steel Oil Pans
AJUSA 00561300 Exhaust Pipe Flange Gasket
Gabriel 43180 Spring Assist Carrier
Mix me 4576