4into1

DW-200

Dynatek Dyna Motorcycle Ignition Coil Wires - 7mm - Copper Core - DW-200 Black

Spark Plug Wires

Black, 7mm, copper core Dyna ignition wires. This is a set of 4 wires with plug caps, rubber boots and connectors included.
Comes from Dynatek as two 48" wires with caps on both ends. You simply cut the wires in half to make four 24" wires with caps.
The copper core wires are perfect for stock coils or the Dyna coils and work with points or electronic ignition like the Dyna S. If you're using the Dyna 2000, get the suppression core wires.

Black, 7mm, copper core Dyna ignition wires. This is a set of 4 wires with plug caps, rubber boots and connectors included. The copper core wires are perfect for stock coils or the Dyna coils and work with points or electronic ignition like the Dyna S. If you're using the Dyna 2000, get the suppression core wires.

Comes from Dynatek as two 48" wires with caps on both ends. You simply cut the wires in half to make four 24" wires with caps.

Dynatek "Dyna" Wires are made from high grade automotive, silicon jacketed, high tension cable. All wires are supplied with finished spark plug boot ends and loose coil terminals to allow the final length to be determined by the user. Wires are available with a solid copper core for use on older vehicles where electrical interference is not an issue. For use on new vehicles with electronic advance ignitions or other sensitive electronic equipment, use DYNA suppression wires with a high grade graphite core for best performance and electrical noise suppression. Both wire types ensure maximum energy transfer and a 135 degree snap boot for easy installation

Dynatek part number: DW-200

Dynatek Coil - 12v/3 OHM DC1-1
Airtex AW4056 New Engine Water Pump
Nissan Sentra Drilled Slotted Rotors F32-5425-P-6
Mix me 543