EFIConnectors

lsu4.2_ext_kit

EFIConnectors - LSU4.2 Bosch Wideband Sensor Extension DIY Kit

Lambda Control Units

Connector Housing Pair
Terminals
Wire Seals
Wire Boots

Male side and female side connector PAIR for a Bosch LSU4.2 Wideband sensor. Used to make your own sensor extension, or use it in with the mating connector for a very high quality 6 pin sealed disconnect. Comes with two connector housings, 8 male pins, 8 female pins, 16 wire seals, and 2 connector boots. Steps: Cut 6 wires to the desired length Put wires inside wire covering Put the connector boots over the covering Put wire seals on both ends Strip about 1/8-3/16" (3-4mm) off the wire Crimp the terminals on the wire, all female at one end of the cable, all male at the other end Insert one wire into pin one of a connector housing, insert the same wire into pin one of the other housing Repeat for the remaining 5 wires Engage the pin lock on the connector housing. On the male terminal housing, you slide it to the side of the connector housing On the female terminal housing you slide it in from the side of the housing Test the cable. Once it's known to function, slide the connector boots to the ends, and stretch over the connector to make a nice assembly.

Joe Rocket Mens Airborne Textile Motorcycle Jacket Gunmetal/Black Extra Large XL
Honda Civic Racing Hood Scoop SCOOP1014
Mix me 1767