Entry Guards COSMOSS COSMOSS-MISC-L01-2

COSMOSS

COSMOSS-MISC-L01-2

Door Edge Guard Protector For Most Sedans By COSMOSS, Virtually Invisible / Durable and Cleanly Remove Design, Easy D.I.Y. Installation: No Tools Needed, (16-ft, Black)

EAN: 0763846655864

UPC: 763846655864

Entry Guards


***Refer image 2 for length selection guide**** MATERIAL: High quality TPO rubber material, heat resistance, abrasion resistance, anti-aging, waterproof & UV resistance.
DESIGN: Thin/Slim design yet it efficiently protects your door. "ATTENTION! - NOT SUITABLE FOR DOOR THICKNESS MORE THAN 2mm ( .078 INCH)". ADHESIVE: Built-in strong double-sided adhesive tape and does not melt under hot weather, no glue needed. The adhesive tape is designed to paste on the inside door edge, therefore it will not leave any residue on the outside door after the door trim is removed.
CHOICES: 3 colors (White, Black & Grey) to select to match your vehicle color, almost invincible after installation.
INSTRUCTIONS: EASY D.I.Y install in a few minutes - see product description for installation steps.
ATTENTION!: Our Door Edge Protected Lining works best for door edge thickness up to 2mm ( .078"). Attention to truck/van/jeep owners, please ensure your door edge thickness prior to purchase.

COSMOSS Door Edge Guard. Easy D.I.Y. kit rubber guard for car door edge,1 pc comes in 16-ft length to cut to length, the trim is made of very flexible high quality TPO rubber with internal adhesive tape, no glue needed just peel and stick. It protects door edge from ding into other objects when opening. It prevents nicks and chips and to cover existing damage.

Easy Installation Steps:
  1. Clean the door edge to remove any oil, wax & dust. Make sure the door is dry before continuing.
  2. Uncover the tape from the tip of the lining (Ensure the tape is install INSIDE the door) and peel the red strip off the tape by approximately 2 inches.
  3. Start from the top, insert the lining onto your door edge until the lining is fully seated.
  4. Press the lining with your thumb along the door edge until it is fully seated, then pull the red strip off.
  5. Repeat step 4 until all edges are protected.
  6. Use scissors to cut away unused lining for other door edges.
  7. Let the lining dry up by itself and do not get wet for at least 12 hours.


"ATTENTION! - NOT SUITABLE FOR DOOR THICKNESS MORE THAN 2mm ( .078 INCH)"