all-sun

EM276

all-sun Injector Tester Auto Fuel Injector Tester 4 pluse modes 12V Diagnosis

EAN: 0723800357234

UPC: 723800357234

Fuel Injectors

Operates injectors individually to diagnose fuel delivery problems on petrol vehicles with electronic fuel injection.
Works with engine off and pulse timer may be used with fuel pressure gauge.
Large LED display/4 Pulse Modes. Test Lead: 41.5cm / 16.3 inches.
It can work with any fuel pressure tester. Please NOTE: Gasoline car only, NOT the diesel engine.
Powered by vehicle's 12V battery.

The tester can help diagnose injector problems,you can use it to test each injector individually to help idently stuck,leaking or burnt-out conditions.
It uses 12V vehicle battery for power.
It has 4 pulse modes, the continuous mode (mode 4) helps identify good or bad injector.
The mode lock feature ensures test condition uniformity.
It can work with any fuel pressure tester.

SPECIFICATION
Power Supply:12V vehicle battery
Operation Environment:0-40°C,relative humidity<80%
Storage Environment:-10°C ~50°C, relative humidity<85%
Test Cable Length: 41.5cm/ 16.3 inches
Product Size:147x82x29mm

Operation Instruction
1.Turn off the vehicle's engine.
2. Connect the black clip to the negative terminal of the vehicle battery, connect the red clip to the positive terminal of the battery.
3.Locate the fuel injector which you want to test, then remove the electrical cable from this injector and connect the tester's two pulse output terminals to the electrical connector of this injector.
4.Press the MODE SET key to select the desired pulse mode, the display shows the current pulse mode.

Explanations for the 4 Modes:
Mode1: the tester will output 1 pulse, whose pulse width is about 250ms.
Mode 2: the tester will output 50 pulses, every pulse's pulse width is about 7ms.
Mode 3: the tester will output 100 pulses, every pulse's pulse width is about 3.5ms.
Mode 4: the tester will output continuously at the rate of 50 pulses per about 1450ms, every pulse's pulse width is about 7ms.
At any time, you can press the PULSE key again to stop outputting pluse.
5. After you have selected the desired pulse mode, press the PULSE key.
The tester outputs pulse(s) to the injector under test, the pulse signal indicator will light as indication.

PLEASE NOTE: Gasoline engine only, NOT the diesel engine.

SG Tool Aid 23500 Back Probe Kit
OTC (3054E) Noid Lite/IAC Test Kit
ABN Fuel Injection Pressure Test Kit – Comprehensive Universal Set with IMPROVED Flex Hoses, Fittings, and Instructions
Tool Aid 23970 In-Line Spark Checker Kit for Recessed Plug
ESI 307M Fuse Buddy Mini Current Loop
Melling K-68A O/P Repair Kit
Autometer Replacement Pillar 09 14 Speaker am17326
Mix me 1788