UPGR8

U4210-05

Upgr8 5 Feet Length Stainless Steel Braided Fuel / Oil / Gas Line Hose (-10AN, Silver)

EAN: 0849250009384

UPC: 849250009384

Fuel

Application for: racing fuel, pump gas, fuels with ethanol, alcohol based fuels, motor oil & coolant etc
Size: AN10; Length: 5 Feet (60 Inch)
Inner Diameter: 0.56" / 14.27mm. Outside Diameter: 0.79" / 20.24mm
Working Pressure: 1000 PSI / 69 Bar; Burst Pressure: 5000 PSI / 350 Bar
Operating temperature: -40 Degree F to +350 Degree F

This hose is made to resist extreme heat, abrasion and corrosion. It offers superior flexibility & bending with maximum vacuum service.

Material:

* Inner hose: CPE synthetic rubber.

* The middle layer: 304 stainless steel wire mesh sleeve.

* The outer layer: 304 stainless steel wire.

How to Cut:

For cutting your new steel braided hose to length you will need:

* cutting wheel/ hack saw/ or steel braided hose cutters

* duct tape or electrical tape (work best)

1. Measure your hose and find desired length.

2. Tape hose at measured length needed for application.

3. Cut hose threw the tape you have placed. (This keep the steel braid from fraying.)

4. Remove the tape.

5. Slide one end of hose into end of fitting.

6. Insert the other half of fitting into the hose and begin to push and screw the fitting together.

7. Make sure all connection are tight.

90 Degree -10AN Swivel Hose End Full Flow Steel Braided Black 10 AN, 9090-10B
Straight -10AN Swivel Hose End Flare Steel Braided Black 10 AN, 9010-10B
45 Degree -10AN Swivel Hose End Flare Steel Braided Black 10 AN, 9045-10B
Russell 610040 Red/Blue Anodized Aluminum -10AN Straight Hose End
Upgr8 Universal Aluminum Oil / Fuel / Water / Fluid / Air Line Hose End Fitting (-10AN Swivel, 45 Degree Black)
BOLT-ON RUB INLAY FTPEGS
Standard TS194 Temperature Sending Switch
Mix me 306