Pusher Intakes

67IMS-7

Pusher 3.5 MEGA Intake Manifold 2007.5-2012 Dodge Cummins Gloss Black

Intake Manifolds

Unobstructed 3.5" inlet to two 3" mandrel bent tubes. Fully TIG welded with precise settings to produce optimal penetration without impacting airflow. 50-200 degrees F drop in EGT's .5-1 MPG increase Deletes constrictive emissions equipment Significant gain in throttle response Faster turbo spool

All Pusher intake manifolds for the Cummins 6.7L trucks are built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower egt's, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a factory Cummins gasket and hardware to make installing this intake extremely easy. You will need to delete all of your factory emissions equipment as this manifold does not have provisions to use any of it. This manifold is for off road use only. For an additional charge, select powdercoating colors are available on this manifold.

Kwik-Way Valve Seat Wheel 2 1/4
ARP 4303502 Stainless Chevrolet Applications
Mix me 2596