General Motors

19205164

Genuine OEM Mopar 19205164 - Ponitac Vibe 1.8L Engine

Engine Kits

Original Equipment Engine
Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors).

Installation Check List:

Determine why the original engine failure occurred and make appropriate repairs.

Insure this engine is the same application as the one being replaced.

Clear all computer diagnostic codes from the vehicle prior to installing.

Exchange the oil pan and pick up tube.

Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets).

On crankshaft bolts that are drilled through sealant must be applied to avoid leaks.

Install new thermostat & gasket.

Replace the timing belt.

Remove all "cap-plugs" orifice covers.

Replace water pump.

Install replacement sparkplugs & wires.

Exchange the flywheel and bolts.

Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors).

Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer.

Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze.

Drain excess oil and coolant from exhaust system.

If equipped with an engine oil cooler the radiator or external cooler must be replaced.

Insure the cooling system is flushed and functioning properly.

Torch Spark Plug E6TC NGK BP6HS Denso W20FP-U
BMW Genuine Repair Kit Cylinder BMW1102625
Mix me 862