AEM Electronics

30-6600

AEM Series 2 Plug and Play EMS Nissan NX SE/XE 1.6L/1597ccL4 VIN: E [GA16DE] 91-93

EAN: 0678717770716

UPC: 678717770716

Engine Management Systems

Fitment: Nissan NX SE/XE 1.6L/1597ccL4 VIN: E [GA16DE] 91-93
Injector Outputs: 4 Peak and Hold, 8Saturated
Coil Outputs: 4
Selectable direct drive or 0-5V Coil Output: Yes
Direct plug in, no jumper harness required: Yes

AEM'series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. This means you do not need to replace any parts of the harness or sensors, just plug the EMS into the harness and begin tuning! The Series 2 EMS allows you to control every aspect of your 2.0L SR20DE. From rev limit, timing, adding different sized injectors, boost control, nitrous injection, even anti-lag and individual cylinder fuel and timing trims, the Series 2 EMS gives you total control from an easy to use interface.

*50mm AEM Trigger Disc included. Some applications may require a 54mm Trigger Disc AEM Part#30-8762

Outputs

More Info:
-General purpose LS outputs: 12
-General purpose HS outputs: 4
-Individual cylinder ignition trims
-Individual cylinder fuel trims
-Inputs
-Trigger inputs (Ref/Sync): 4
-Analog voltage inputs: 18
-Configurable Analog/RTD/Thermister inputs: 4
-Switch inputs: 5
-Lambda inputs: 2x
-Knock sensors: 2
-User adjustable knock sensor center frequency
-Communication
-USB comms
-RS232 comms
-Communication cables included
-Fully enabled editing/logging software included
-CAN bus equipped
-RS232 datastream output: 19 ch
-CAN datastream output: 19 ch
-Communicates with AIM Dash/Dataloggers
-Communicates with Racepak Dash/Dataloggers
-DATA Acquisition
-Internal data logging: 1 MB
-Maximum internal logging rate (per channel): 250 Hz
-PC logging

Weld Racing Pro Star (Series 96) Polished Aluminum - 15 X 10 Inch Wheel
1551989 SUPPORT Warranty FEBEST 2177 TT9RL 2177-TT9RL-AMZ-1551989
Mix me 2508