Kisan Electronics

P75W

Kisan pathBlazer P75W -  Headlight modulator - ISO-Tap single wire hook-up. Fits most SINGLE headlamp

Headlight Assemblies

Compact size plug-n-play - fits in tight space Programmable sensitivity - for Daylight sensor
CAN-bus compatible - for newer bike models
Dual Side-by-side versions - or Dual Hi/Lo versions
Low cost version - single wire ISO-tap hook-up
Designed, developed and assembled in USA

P75W unit is designed to modulate a single headlamp up to 75W max - for most Harleys, Honda, Suzuki, Yamaha, Kawasaki cruiser models. It is very compact - only 0.6" (15mm) square. It can easily fit inside even a small headlight bucket or wired-in with the headlight harness. The internal circuitry is controlled by a microprocessor, which allows precise flash patterns, overload detection and reverse polarity protection, which makes it a fool-proof installation. pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the lo-beam remains untouched, so you won't be without headlights. P75W comes with a detachable daylight sensor (SN-3M), which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot sense enough daylight. Daylight Sensor is programmable. If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. pathBlazer uses a soft-switching technique. It throttles the current flow through the filament of the headlamp, so that appropriate intensities are maintained for modulation. This also prevents any "thermal shock" to the bulb filament, which can damage or shorten its life. Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation. ¦ DO NOT use on headlight bulbs higher than 75W ¦ DO NOT use on bikes that have bulb-check system or CAN-bus monitoring.

2008 Triumph 800 America Motorcycle High Performance Sealed Battery
Rugged Ridge 11209 01 Black Windshield 11209-01
Mix me 196