Kisan Electronics

25LED

Kisan tailBlazer 25LED - GoldWing 1500 Spoiler LED lite-bar 2-pin plug-in

Accessory Lights

Hybrid electronics plug-n-play - simple bulb replacement Dual function circuits - intensity control for tail & brake function
Deceleration flash - exponential decay over 4-Sec
LED option - replaces G4 Halogen bulb element
Low cost version - single wire ISO-tap hook-up
Designed, developed and assembled in USA

25LED unit is designed for Goldwing 1500 SE models with the spoiler LED light bar. 25LED unit mounts on the back of the trunk lid. Please note! This is a special unit designed to work with a split voltage supply. Nominal voltage change is from 6volts to 12volts when the brakes are applied. Motorcycle Safety Foundation (MSF) suggests that you pump your brakes at each stop. tailBlazer does it automatically, and by flashing the LEDs at maximum brightness. WHAT DO THEY SEE? As soon as you tap your brakes, drivers behind you will see a rapid flash of the brake lights. This sudden flashing invokes immediate attention. WHAT WILL THEY THINK? tailBlazer uses a flash pattern which decays exponentially - a well-recognized deceleration warning. The attention to the initial flashing now changes to a clear recognition that you're beginning to slow down! Simply flashing brake lights or flashing them on & off will get the attention of drivers behind you, but it doesn't invoke anything else. Every split second of delay in their reaction reduces your safety margin. The internal circuitry is controlled by a microprocessor. The microprocessor allows for customizable features. The microprocessor can be programmed to adjust intensity of the Running Light function of the light bar. Simply hold the brakes and then turn the ignition on three times quickly. There are two selectable intensities "High" and "Low". Deceleration flash pattern for the brakes will always be at full intensity.

Ferrea F1121P-8 SBC C/P 2.080IN INTAKE
MOROSO
Mix me 1028