Kisan Electronics

P115W-A3-S2

Kisan pathBlazer P115W-A3 - Headlight Modulator For BMW AMP 3 Pin Connector Stage 2 CANbus

Wiring Harnesses

Compact size plug-n-play - fits in tight space Programmable sensitivity - for Daylight sensor
CAN-bus compatible - for newer bike models
Dual Side-by-side versions - or Dual Hi/Lo versions
Low cost version - single wire ISO-tap hook-up
Designed, developed and assembled in USA

This is a Dual Channel configuration. It is EXTERNALLY mounted and does not fit inside the headlight assembly. P115W-A3-DHLdesigned for BMW motorcycles with an AMP 3-pin connector. This unit modulates ONLY the high beam while the low beam stays solid. This is possible because on most newer models, the lo-beam remains On when the hi-beam is turned On. Side-by-side duals, triple bulbs or 4-plex arrangement - this unit is designed to give you the maximum conspicuity. Unit is 1.0" (25.4mm) by 1.35" (34.4mm), and externally mounted. The matching AMP connector makes this a plug-n-play operation. pathBlazer circuit modulates the hi-beam and lo-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever! MAX power rating is 115 watts. DO NOT EXCEED! P115W-A3 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.

GT Styling | 90115 | 91-92 | Dodge | Colt | 200 Gt | Sunroof Wind
FORD
Mix me 2099