XADO Chemical Group

XA12037

XADO EX 120 (Revitalizant) - MOTO (syringe 8 ml)

EAN: 0818887011718

UPC: 818887011718

Engine & Oil

Restores worn surface of engine cylinders, eliminates microcracks and scratches
Increases and levels compression in cylinders
Protects friction surfaces against wear
Reduces fuel consumption considerably
Increases service life of an engine by 3 times

Revitalizant EX120 MOTO is designed for antiwear protection, restoration and protection of engines of motor equipment with combined or separate lubricating system with capacity up to 1000 cm³ (for motorbikes, motorcycles, snowmobiles, personal watercrafts and household motor equipment, etc.). Products is applied to motorcycles, motorbikes, snowmobiles, personal watercrafts and household motor equipment, lawnmowers, chain saws etc. Application instructions for engines with combined lubricating system: Introduce the content of the syringe* into the petrol tank before fuelling Fill the tank with fuel Start the engine and let it idle for 2-3 min Operate the engine in normal mode * It is recommended preliminary to dissolve the content of the syringe in a small amount of oil (20-30ml) at its temperature of exceeding +25°C. Application instructions for engines with separate lubricating system: Warm up the engine to the normal operating temperature Empty the contents of the syringe into the oil filler neck Start the engine and let it idle for 2-3 min Operate the engine in normal mode Note: The compound is equally effective for application to two- and four-stroke internal combustion engines of all brands Does not influence the wet clutch operation It is not recommended to change oil in four-stroke internal combustion engines until the end of treatment The treatment is considered complete after not less than 1,500 km of run (approx. 20 hours of engine operation) If the engine capacity exceeds 1000 cm3 it is necessary to double the dosage The revitalizant is compatible with any additives, metal conditioners, remetalizants irrespectively of its application sequence Protective ceramic-metal coating is formed on the metal surface of any alloys. If the wear rate is close to 100%, the destroyed part are subject to replacement

DD7 BUILDER KIT CHR
WELLS
Mix me 1022