Paxton

1201860-1P

Paxton 1201860-1P Tuner Kit (no carb. hat, compressor bypass or discharge pieces), Universal Big Block Mopar 440 Carbureted System, NOVI-1500

Compressors

Big Block Mopar 440
** NOTE : PRODUCT IMAGE MAY NOT BE VEHICLE SPECIFIC

These are universal supercharger kits designed for vehicles equipped with carbureted big block Dodge 440 RB engines. Supplied pulley ratio will produce approximately 5-6 psi at 6000 RPM on a lightly modified 440CI engine. Horsepower gains (depending on boost levels engine volumetric efficiency etc.): 30-75%+. Designed for OEM Dodge Twin V-Groove Accessory Crank Pulley The supplied crank pulley is designed to work with the OEM Dodge twin V-groove accessory crank pulley. For correct belt alignment the proper accessory drive crank pulley must be used. Fuel Pump and 4150 Carburetor Required This universal system requires the installer to source a high volume fuel pump and a properly jetted 4150 style carburetor unit (with mechanical secondaries). Vehicle throttle cable/arm modifications may be required. A replacement hood or hood modifications may be required depending upon the type of intake manifold and carburetor enclosure / bonnet installed on the engine. Included Components: *Novi 1500 supercharger (CW rotation; curved discharge) with 10-rib 3.875 diameter pulley *Twin billet aluminum mounting plates for rigid supercharger attachment with all necessary hardware - Integrated manual belt tensioner with dual bearing billet aluminum idler - OEM alternator mounting provisions *Supercharger drive assembly: - Billet aluminum supercharger crank pulley with hard anodize finish (6 diameter) - 10-rib drive belt spacer and all necessary hardware *Supercharger oil drain assembly *Supercharger oil feed assembly *4 aluminum inlet ducting with silicone sleeves stainless clamps and cone-type high-flow filter *3.5 aluminum discharge tube with silicone sleeves and stainless clamps *Aluminum race bypass valve with tube and mounting flange (not included in 1201860-1 / 1201860-1P tuner kits). Note: supplied compressor bypass valve installation requires welding in installer specified location *Cast aluminum carburetor hat / bonnet (not included in 1201860-1 / 1201860-1P tuner kits)

ACDelco PT735 Female Connector with Lead
Rox Speed FX Elite Handlebar 1RP2SE
Mix me 2454