SparkFun

Danger Shield for Arduino

EAN: 0845156001033

UPC: 845156001033

Body

Three linear slide potentiometers connected to the Arduino's analog pins 0 through 2.
Three momentary push buttons connected up to the Arduino's digital pins 10 through 12. Those lines will go low when the buttons are pressed.
A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.
Capacitive Touch pad - Using the CapSense library to sense touch.
A buzzer - so you can get sound out of your Arduino

The Danger Shield mounts on top of your Arduino or Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential; we can't wait to see what you're able to do with it! The shield's features include:

Capacitive Touch pad - Using the CapSense library to sense touch. This new version uses a different temperature sensor. This product comes as a kit of parts, which you'll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily; but always check your component orientation before soldering!

Kit includes: 1x PCB Danger Shield Kit, 3x Slide Potentiometers - 10K, 1x 7-Segment LED - Blue, 1x 8-bit Shift Register - 74HC595, 1x Temperature Sensor - TMP36, 1x Miniature Photocell, 1x Buzzer, 1x Basic LED - Red, 2x Basic LEDs - Yellow, 1x Mini Push Button, 3x Momentary Push Buttons - 12mm Square, 11x Resistors - 330 Ohm, 2x Resistors - 10K Ohm, 1x Resistor 1M Ohm 1/6W, 2x 8-pin Arduino Stackable Headers, 2x 6-pin Arduino Stackable Headers