Mstc

FORDV10STUDS

Ford 6.8 Liter V10 Stainless Exhaust Manifold Studs, Stud Kit (one side)

Studs & Nuts

ALL A2-70 STAINLESS STEEL
FAR LESS EXPENSIVE THAN REPLACEMENT HARDWARE FROM FORD
WILL NOT RUST LIKE THE ORIGINAL STUDS
USED ON OUR PLOW TRUCK FOR YEARS WITH NO PROBLEMS
WE HAVE SOLD THESE KITS TO HUNDREDS OF SATISFIED CUSTOMERS

This is a set of ten stainless steel studs (with an allen drive for easy installation), and serrated face flange nuts. They will replace the factory hardware that rust and break on the Ford 6.8 liter V10 engine. These engines are notorious for needing the exhaust manifolds and hardware replaced. We not only assemble these kits from our stock, but some of us here have also installed them with great results. Why use steel hardware that is just going to rust again? It is always a good idea to use anti-seize on an application like this, it can be found in any good auto parts store. NOTE: These are meant to secure the exhaust manifold to the cylinder head, YOU WILL NEED ONE KIT PER MANIFOLD We also offer a tap and drill kit to help with this installation, you can find it on our Amazon storefront.

Remflex 3023 Exhaust Gasket for Ford V10 Engine, (Set of 2)
Tap and Drill for Ford 4.6, 5.4 & 6.8 Liter V8 & V10 Exhaust Manifold Studs