12003

Revolution Electronics Electric Fuel Pump Controller. Primes the pump on key-on and turns the pump off if the engine stops.

Electric Fuel Pumps

Monitors the tach signal - as long as there is a tach signal present, the pump is allowed to operate. If the engine stops, so does the fuel pump. Works with both inductive (stock) and square-wave (aftermarket) tach signals.
Turns on an electric fuel pump for 3 seconds on initial key-on. This primes the fuel system and tops off the carburetor's fuel bowls.
Controls an electric fuel pump when a classic car or truck is upgraded from a mechanical fuel pump.
Includes an intermal self-resetting 7 amp fuse and 15 feet of 16 gauge wire to connect the fuel pump. Higher amperage pumps can be controlled by adding an external relay.
For 12V vehicles. 2 by 1.5 by 1 inches. Fully potted. Made in USA.

Designed to safely control an electric fuel pump when a classic vehicle is upgraded from a mechanical fuel pump to an electric fuel pump. Powers the pump for three seconds on initial power-on to fill the carburetor bowls. After those first three seconds, the pump will only run if there is a tach signal. If the tach signal stops, the pump shuts off. Includes an internal 7A self-resetting fuse, 15 feet of 16 gauge wire, and the necessary hardware for most installations.

Carter P60504 Electric Fuel Pump
Carter P4070 Electric Fuel Pump
Mr. Gasket 1561 Fuel Pressure Gauge
Mr. Gasket 2975 Fuel Pressure Gauge Adapter
Kensun HID Xenon Conversion Kit All Bulb Sizes and Colors with Slim Digital Ballasts - 9005 (HB3) - 5000k
SUPERWHOLE
Mix me 4295