Danmoto

EL-00044

1998-2010 Honda VFR 800 Interceptor O2 Sensor Eliminator

Electronic Ignition

Reduces Surging
Replaces the OEM O2 Sensor
Increased Performance and reduced Engine heat
Improved Throttle response
Plu&Play Installaion


The O2 sensor which is installed in the stock exhaust system of this bike is used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.

This is done only in a very limited RPM range under certain load situations. The intention behind it is not to improve performance; it's aimed to reduce the emission of the engine in the specific RPM/Load situations which are tested during the homologation process.

This can result in delayed throttle response or unsteady power delivery.

If you perform changes on your exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.

The eliminator simulates the signal give from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions.

If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installing an O2 sensor eliminator.

Picture is for reference only, actual item might differ in appearance

K&N HA-8098 Honda High Performance Replacement Air Filter
Coverking Custom Fit Front 50/50 Bucket Seat Cover for Select Ford Fusion Models - Genuine Leather (Beige)
Polaris Sportsman Brand Starter Motor Pa-106N
Mix me 2449