XZN14

14mm Triple Square XZN Socket for VW/Audi

Triple Square Drive

Used on Mk5 and Mk6 VW's to remove the rear calipers(except R32).
Used on Mk5 and MK6 VW's to remove the front struts from the knuckle.
3/8" Drive
Hardened Steel with Chrome Plating for long life.
Lifetime Warranty (not for use on air tools)

This is the tool that is needed to remove the rear calipers on the Mk5 and Mk6 VW's(except the R32, it uses a 16mm socket). It is also used to remove the front struts from the steering knuckles.It has a 3/8" Drive and its short lengths allows you to easily reach behind the calipers to loosen and remove the bolts.If in doubt what size is needed, measure the bolt from the one tip to the other as shown in the picture, and that dimension is the size of the tool that is needed.