Genssi

50W-RSTR

GENSSI 50W LED Bulb Fast Flash Load Resistor HID Kit and LED (Pack of 2)

Ballast Resistors

One resistor is required for each turn signal bulb or headlight plug; Installation is simple; just connect one wire of the resistor to the ground and the other one to the positive wire; The Resistor should run parallel to each other
Designed to be installed with HID kits that flicker and cause dash light out warnings
High working temperature; Do not mount on plastics
This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications
Pack of 2; Includes 2 resistors

GENSSI pair of 50W Resistors used for vehicles as load bulb. We say they are 6-8 Ohms depending on inventory and stock. These 6-8 Ohm, 50 Watt resistors will work on any vehicle and can be connected across the turn signal bulbs/headlight wires to simulate the load of a regular filament bulb (2 Amp load).

50W 6Ohm LED Load Resistors for LED Turn Signal Lights or LED License Plate Lights (Fix Hyper Flash, Warning Cancellor)
LED Light Bar Nilight 20 Inch 126w LED Work Light Spot Flood Combo Led Bar Off Road Lights Driving Lights Led Fog Light Jeep Lights Boat Lighting ,2 Years Warranty
KIA Optima Replacement Tail Light Assembly Outer, OEM - Driver Side
Brand Smog Secondary 1997 1998 Complete SP34
Mix me 3412