D-Rings Tiedown Attachments - 04 Pack

99359-04-04

Surface Mount Tiedowns D-Ring 1,200 lb, Capacity 2-hole - 4

Tie Downs & Anchors

1,200 lb. rating (straight pull). WLL is 400 lb. capacity*.
The steel portion of this attachment measures 3 -1/2" in diameter.
The 1/4" diameter ring measures 2" wide X 1-3/4" long.
The "top cap" is 16 gauge.
Two 1/4" diameter mounting holes on 1-1/4" centers secures the attachment to the floor.

This listing is for FOUR (4) tie down attachments. Purchased individually @ $3.25 each, the cost would be $13.00 - therefore you SAVE $2.05. This flush mount d-ring has a 1,200 lb.* vertical pull weight rating. The flush feature is attained from a beveled plastic ring. The ring is pressed togehter, not welded. This steel attachment is zinc coated to inhibit corrosion. To obtain maximum strength it is recommended to install these d-rings with bolts, lock nuts, and fender washers (wide diameter). It is not recommended to attach more than one tie down strap at a time to this d-ring. *WORKING LOAD LIMIT: The maximum load weight a tie-down should be subjected to during normal use. To assist in making the proper tie-down choice the Federal D.O.T. requires the W.L.L. to be 1/3 of the Rated Capacity.

Ready-Aire K10170NC R134a Retrofit Kit
Wells SW6713 Blower Control Switch
Mix me 3456