XADO

XA 10202

XADO Gel-Revitalizant for diesel engines (3-tube package deal)

Motor Oils

Restores and protects friction parts of the cylinder-piston group, crank and gas distributing mechanisms against wear.
Reduces fuel consumption considerably (by up to 30% at idling).
Increases oil pressure to the nominal one.
Regains and increases compression in cylinders.
Increases engine power, improves acceleration capability.

Designed for protection of engine parts against wear and restoring repair of diesel engines without disassembling. It is necessary to use up to 3 tubes (9 ml) for treatment (please see information about application and dosage below). The gel forms a new cermet coating on friction surfaces (the engine parts grow in volume, restore their original geometry). As a result a renovated unit exceeds the performance level of a new one and will serve you 2-4 times longer. Application: Treatment of the engine with the oil system 3-10 liters. Step 1: Squeeze out the contents of one tube into the oil mouth of the engine warmed up to the running temperature. Start the engine and let it idle for 5-10 minutes. Step 2: Do as described in Step 1 after 60-150 miles run Step 3: Do as described in Step 2 after 60-150 miles of run Dosage: Oil system volume, L:3-10 L, necessary quantity of tubes (9 ml) - 3 tubes, treatment scheme: 1+1+1, tubes for new engines - 2 pcs. Oil system volume, L: 11-20 L, necessary quantity of tubes (9 ml) - 21-30 tubes - 6 tubes, treatment scheme: 2+2+2, tubes for new engines - 4 pcs. Oil system volume, L: 21-30 L, necessary quantity of tubes - 9 pcs, treatment scheme: 3+3+3, tubes for new engines - 6 pcs. Note: *Do not change oil until the end of the treatment! *Revitalization is considered to be completed after 1500 km run. *Treatment can be done at idling (4 hours are equivalent to 120 miles run); *New engines should be treated in one step - 2 tubes at one time. *The protective cermet coating forms on any operative mechanism; in case the mechanism (engine) is in critical state (wear 100%) worn parts must be replaced. General characteristics of the cermet layer: microhardness - 750 kg/mm2; high corrosion resistance; roughness Ra up to 0,06 mkm.

3 Pack Lot of XADO Restoration for Gasoline Engines Gel-revitalizant (X3)
2004 Honda VT1100C2 Shadow Sabre Motorcycle Touch-Up Paint EcoJar+ - Candy Durango Red R274 - Essential Package
VDO PM9358 Blower Motor
Mix me 2729