SP Performance Rotors

F54-117-1

04-05 Ford Freestar - Rear Cross Drilled and Slotted Rotors

Rotors

1 Set of Left and Right Rear Rotors For: 04-05 Ford Freestar (REAR)
Finished with SP Performance Exclusive ZRC Gray Coating to protection against corrosion.
Maximum air circulation - Increased cooling - Increased bite - Improved braking - Reduced fade - Increased Safety and Reliability
Sinusoidal Curved Chamfered Hole. Promotes cooling and minimizes stress, reducing the possibility of heat checking while increasing both rotor and pad life.
Direct Bolt-On No Modifications Necessary ------ Note: Rotor Image Is Not Vehicle Specific

SP Performance Cross Drilled and Slotted Brake Rotors are a unique design offering the best combination of cooling and out-gassing. Special features include the exclusive SP Sinusoid Curve chamfer that has no edge. This is accomplished by the use of an outer radius curve rather than a countersink. The radius curve virtually eliminates any edge on the surface of the hole. With no edge, there is less stress build up, thus reducing the chance of surface checking. This smooth surface also makes the rotor more pad friendly by reducing the wear of the pad caused by the friction scraping against a sharp edge.

Each rotor is coated with SP's flat gray ZRC. It provides long-lasting protection against corrosion in the most hostile salt-water environments. After being applied, ZRC provides the highest level of galvanic protection. The film of ZRC is conductive. After the coating heats up during use, it bonds permanently to the metal surface. It will not allow the metal to corrode, even when the surface is scratched.

Note: Please check Title and Product Features to verify the vehicle application to make sure these rotors will fit your vehicle before ordering.

3/8 x 3.13 Bronze Bullet® Interrupted Spiral® Valve Guide-Liners®:370 I.D.
LEDQUSA A 1265 Three Button Switch A-1265
Mix me 1692