SP Performance Rotors

F54-078-P-3

1999 Ford F250 4WD SD (DRW W/4WABS, 3.73, 4.10, 4.30 Gear Ratio, From 3/22/1999 13 1/64 Rotors) Front Cross Drilled and Slotted Rotors

Rotors

1 Set of Left and Right Front Rotors For: 1999 Ford F250 4WD SD (DRW With 4 Wheel ABS, 3.73, 4.10, 4.30 Gear Ratio, From 3/22/1999 13 1/64" Rotors) Front
Finished with a Bright Silver Plating to protect against corrosion.
Maximum air circulation - Increased cooling - Increased bite - Improved braking - Reduced fade - Increased Safety and Reliability
Sinusoidal Curved Chamfered Hole. Promotes cooling and minimizes stress, reducing the possibility of heat checking while increasing both rotor and pad life.
Direct Bolt-On No Modifications Necessary

SP Performance Cross Drilled and Slotted Brake Rotors are a unique design offering the best combination of cooling and out-gassing. Special features include the exclusive SP Sinusoid Curve chamfer that has no edge. This is accomplished by the use of an outer radius curve rather than a countersink. The radius curve virtually eliminates any edge on the surface of the hole. With no edge, there is less stress build up, thus reducing the chance of surface checking. This smooth surface also makes the rotor more pad friendly by reducing the wear of the pad caused by the friction scraping against a sharp edge.

These rotors are electro-plated with a bright Silver Zinc Finish to give a more appealing look. Electro-plating forms a metallurgical bond between the plating and steel, forming an iron rich alloy with tenacious bond where it will form its own protective oxide layer. Electro- plating is very effective in combating the corrosion of the rotor.

Please check and verify the vehicle application to make sure these will fit your vehicle before ordering.

Evergreen HSHB5031 Cylinder Head Gasket Set Head Bolt
1946 1954 General Chrysler Cylinder Cylinder WC-6VL
Mix me 64