3M

08582

3M 08582 36 Door Edge Protection Film

EAN: 7262318508996

UPC: 051135085820

Interior Care

Protects door edges from chips, scratches, and scuffs
Apply by hand with no tools required
Installation made easy with step-by-step instructions; just provide soap and water and squeegee
Virtually invisible and cleanly removable
Helps keep appearance looking new

3M Door Protection Film is a super tough 6-millimeter thick clear coated urethane film that helps preserve your vehicle's finish. It's made from the same material as the professionally installed product used at car dealerships. It helps protect against chips, abrasion and weathering--including stone chipping, door dings, and most types of environmental damage. It is virtually invisible and clear-coated to help make it resistant to yellowing and staining. Once applied, no special care is required. The application is permanent.

Frequently Asked Questions

Can I use wax over 3M Paint Protection Film?
Yes. When waxing the vehicle, some wax may build up along the film edges. This can easily be removed when dry with a soft cloth, such as a 3M Microfiber Detail Cloth (39016). Do not use any waxes containing dyes or waxes that are not recommended for urethanes. Abrasive polishes and/or rubbing compounds are not to be used.

What products does 3M recommend to best maintain 3M Paint Protection Film?
3M makes a variety of products to help maintain the beauty of your vehicle. 3M Car Wash Soap (3M Part #39000), 3M Show Car Paste Wax (3M Part #39526) and 3M Liquid Wax (3M Part #39026). The best surface cloth to use is the 3M Detailing Cloth (3M Part #39016) since others may scratch the surface of the film.

How is 3M Paint Protection Film removed?
If desired, film can be removed at any time by picking up a corner of the film and pulling the film off the vehicle surface at a 90-degree angle. If the film has been present a long time, or if the film and vehicle are cold, a heat gun or hair dryer may be used to soften the adhesive, allowing easier removal. If any adhesive remains on the vehicle after removal of the film, it can be removed by using 3M Adhesive Remover (3M Part #03618), according to the package directions.

If 3M Paint Protection Film is removed from the vehicle, can it be re-used?
Once the film has been applied and set, the adhesive will not stick a second time.

After 3M Paint Protection Film has been removed, how do I get any excess adhesive off my vehicle?
If any adhesive remains on the vehicle after removal of the film, it can be removed by using 3M Adhesive Remover (3M Part #03618), according to the package directions.

(4) Universal Clear Side Door Handles Paint Scratches Protective Film Vinyl
iJDMTOY 6 by 60 Inches Clear Door Sill Paint Protection Scratch Film Vinyl Sheet
XPEL Clear Universal Door Sill Guard (60 x 2.75) Paint Protection Film Kit
Self-Healing Clear Paint Protection Bra—Door Sill Kit (64in x 3in)
3M Scotchgard Clear Paint Protection Bulk Film Roll 6-by-60-inches
BMW (88-03) Door Stop check strap Pin Clip (x2 clips)
1962 1971 Dodge Ignition Switch Cylinder ---
Mix me 1353