Dorman

911-106

Dorman 911-106 Vapor Canister Vent Valve

EAN: 0019495291930

UPC: 019495291930

SKU: DOR911106

Vapor Canisters

Used to seal the EVAP canister during startup system check
The ability to seal the vent is necessary for the on board diagnosis of the evaporative emission control system
Includes hardware for complete installation

The vapor canister vent valve is located on the EVAP canister and is used to seal the canister during startup system check. The solenoid responds to signals from the ECM. When the ECM sends an on signal, the coil in the vent valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of the evaporative emission control system. The vent valve is used only for diagnosis and usually remains opened. Vent valves are primarily replaced due to reasons like electronic solenoid failing due to water intrusion, it contaminates entering the system due to an O-ring failure causing the valve to stick. It is often the solenoid will not engage or it will engage but the pintle will not move its complete required path of travel. Its failure causes the check engine light to set with EVAP Code System that is small leak diagnosis.

Motorcraft CX1597 Vapor Canister Purge Solenoid
Dorman 911-305 Evaporative Fuel Vapor Canister
Motorcraft FC975 Fuel Cap - Push Lock Type ONLY
Bosch Original Equipment 15717 Oxygen Sensor
Dorman 911-258 Evaporative Fuel Vapor Canister
Aimco W906575 Rear Drum Brake Wheel Cylinder
MOROSO 65414 Carburetor Float Screw M28-65414
Mix me 1691