Rvinyl

c_rwrap_R3DCF_24_10

Carbon Fiber Film Twill Vinyl Sheet Roll Wrap - 120 3D Carbon Fiber (Black)

Vinyl Wraps

Rwrap R3D Carbon Fiber film is an adhesive backed, ultra flexible and realistic.
This is a 24 inch wide sheet of adhesive backed film designed for curved applications.
Universal trim to fit sheet can customize most hard surfaces.
Step by step video installation application guide online. Toll free phone support provided.
100 Percent Satisfaction Guarantee, 5 year warranty, Installer Friendly Film.

Rwrap Carbon Fiber film is designed to customize any hard non-porous surface. This series is a single ply textured adhesive backed film that allows for semi-permanent application. It is intended for extreme curved applications. How to apply Rwrap Film: Measure the application area where the film is going to be applied. Take into consideration any bends or compound curves that may need the material to bend when wrapping. Choose the most applicable size. A Tailor's Tape works well when measuring. With the properly sized film selected, simply mist the film and application area with the recommended application solution, apply it over the area, heat the film with a hair dryer, apply it to the surface with a squeegee or other hard card and trim away the excess. If it sounds hard, don't worry we provide online instructional videos. Recommended application Tools? We recommends the use of an application squeegee which will reduce air bubbles during installation and aide in heat conforming the film to your application area. By using a low friction sleeve, you will reduce the chance of scratching your film during application. Application solutions such as Rapid Clear will remove any dirt or debris from your application surface and Rapid Tac will aide in the wet application of our adhesive backed film kits.

Frewdenburg-Nok Crankshaft Seal
Support BEARING MERCEDES SPRINTER BG41033
Mix me 836