D-Rings Tiedown Attachments - 20 Pack

80849-12-20

D-Ring Recessed Tiedowns 6,000 lb. Capacity Square Holes - 20 Pack

Tie Downs & Anchors

6,000 lb. rating (straight pull). WLL is 2,000 lb. capacity*.
The steel attachment is zinc coated to inhibit corrosion.
The base measures 5" x 4-1/2". Hole pattern is 3" x 3-1/2" on centers.
Recessed dimension is 2-1/2" in diameter with a flat edge. The 7/16" diameter ring measures 1-3/4".
The ring pivots on a 5/16" threaded stud. The pan has a 1/4" drainage hole

This listing is for TWENTY (20) recessded tie down attachments. Purchased individually @ $5.95 each the cost would be $119.00 - therefore you SAVE $51.05. This tie down attachment has a 6,000 lb.* vertical pull weight rating. To install this attachment requires routing, or cutting a hole in the floor. The price is for TWENTY - above two are shown for complete visibility. This recessed d-ring has square holes punched for receiving carriage bolts, providing a smooth and relatively "trip free" surface. The steel attachment is zinc coated to inhibit corrosion. When in use the ring portion raises for application and lies down when not in use, thus creating a flush surface.This tie down attachment is plenty strong and is able to receive multiple tiedown straps simultaneously. To obtain maximum strength it is recommended to install these d-rings with bolts, lock nuts, and fender washers (wide diameter). For installation purposes it is easiest to cut a template and then transfer to the desired location. WORKING LOAD LIMIT: The maximum load weight a tie-down should be subjected to during normal use. To assist in making the proper tie-down choice the Federal D.O.T. requires the W.L.L. to be 1/3 of the Rated Capacity.

20 Land Rover Range Rover Mk3 02 to 12 Lenso Alloy Wheels (Set of 4)
BANKS
Mix me 3830