Dynojet

1020-0079

SENSOR ELIM. PLUG TRI-02

Accessories

The system is designed to read the oxygen sensor under certain conditions and temporarily change the air / fuel ratio.Optional high-performance oxygen sensor optimizer for easier adjustments through the Dynojet control center software.Use with the Power Commander III USB or Power Commander III USB EX.Note: With some motorcycles you have to disconnect the O2 sensor cable so that the engine electronics accept the revised values from Power Commander III USB and the performance can be increased.The
closed loop circuit has a very limited operating range, which is only in effect while holding a steady speed at certain RPM's and throttle positions.
In this limited area, the stock system (with or without the Power Commander) will gradually and temporarily lean out the air fuel ratio in an attempt to achieve an air / fuel ratio of 14.7:1 (stochiometric).
The oxygen sensors can be disconnected but this will trip the F.I.
dash warning light.

SENSOR ELIM. PLUG TRI-02

FO-430BC5116 AutoSport Berber 1pc Rear Mat Black/Tan
JOHN DEERE
Mix me 3114