G2 Ergonomics

G2-20-200

G2 Ergonomics G2-20-200 - Throttle Cam System

SKU: tr-170701

Throttles

Machined from 6061 aluminum in the USA!
Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact for an ultra-smooth feel.
Alternate cams to fine tune control included.
Fits inside stock throttle housing with stock throttle cable.
Removable end cap for simple handguard installation

The Throttle Cam System incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening.  The "pulley", or as we call it, "cam" pulls the throttle cable as the rider rotates the grip/tube.  By altering the conventional, circular shaped cam, a vast improvement in control is achieved. The Throttle Cam System has cam options with reduced radius for the first ½ of throttle rotation, which requires a slightly farther turn to achieve the same carburetor or throttle body opening position as a stock throttle.  This slightly longer pull makes a HUGE difference in rider control as the power is rolled on.  The system comes with a "100CAM" - same as stock, "200CAM" - starts out 10% smaller than stock and "400CAM" - starts out 20% smaller than stock.  The radius of the 200CAM and 400CAM increases or "ramps up" to stock size at  ½ throttle to keep overall rotation required to reach full throttle at or near stock rotation. Fits: KTM 2 stroke models 85-300cc (97-14), Husaberg 2 strokes (all), Husqvarna 2 strokes (97-14)

Wahler W0133-1890279 Engine Coolant Thermostat / Water Outlet Assembly
Standard Motor Products RU 32T Tru Tech RU32T
Mix me 1717