Elkhart

06840

Elkhart (06840) 1/2 x 1/2 Flair-It Coupling Flare

EAN: 0742979068406

UPC: 742979068406

SKU: 15002840

Water Heaters

For hot and cold potable water fittings (150 degrees at 100 psi)
Squarely cut end of tubing, slide nut over tubing
Firmly press tubing onto the flare of the fitting
Slide the nut to the threads and hand tighten securely onto the fitting
Nuts are included, Flair-It Coupling Fitting 1/2 inch x 1/2 inch

For hot and cold potable water fittings (150 degrees at 100 psi). Squarely cut end of tubing, slide nut over tubing. Firmly press tubing onto the flare of the fitting. Slide the nut to the threads and hand tighten securely onto the fitting. Turn 1/4 more turn with a wrench if necessary. Do not use any 2 inch pipe dopes, sealants, Teflon tape or other chemical on Flair-It connections. However, Teflon tape should be used on male pipe threads when connecting to female threads. When connecting to brass, galvanized steel or CPVC, use a male Flair-It fitting instead of a female fitting. When connecting Flair-It fittings to a water heater in a mobile home, we recommend using a 1/2 inch flex copper connector off of the water heater. From a flex connector to polybutylene, use a Flair-It male adapter. Do not use in a closed loop system. Joints should not be made under concrete. Nuts are included. Flair-It Coupling Fitting 1/2 inch x 1/2 inch.

GOLDfren 041104K5LX 1 FRONT BRAKE PAD SET FITS: 2008 - 2010 YAMAHA WR 250 R/X (32D1/3)
Standard Motor Products DS 870 Courtesy DS-870
Mix me 4566