Elkhart

6820

Elkhart 6820 1/2 x 1/2 x 1/2 Flair-It Tee Fitting

EAN: 0742979068208

UPC: 742979068208

Categories

FLAIR-IT Fittings FLARED - CONE & NUT Fittings APPLICATIONS FOR HOT & COLD POTABLE WATER Fittings - For hot and cold potable water fittings (150 degrees at 100 psi)
Squarely cut end of tubing, slide nut over tubing
Firmly press tubing onto the flare of the fitting
Slide the nut to the threads and hand tighten securely onto the fitting
Nuts are included, Flair-It Tee Fitting 1/2 inch x 1/2 inch x 1/2 inch

FLAIR-IT Fittings FLARED - CONE & NUT Fittings APPLICATIONS FOR HOT & COLD POTABLE WATER Fittings - For hot and cold potable water fittings (150 degrees at 100 psi). Squarely cut end of tubing, slide nut over tubing. Firmly press tubing onto the flare of the fitting. Slide the nut to the threads and hand tighten securely onto the fitting. Turn 1/4 more turn with a wrench if necessary. Do not use any 2 inch pipe dopes, sealants, Teflon tape or other chemical on Flair-It connections. However, Teflon tape should be used on male pipe threads when connecting to female threads. When connecting to brass, galvanized steel or CPVC, use a male Flair-It fitting instead of a female fitting. When connecting Flair-It fittings to a water heater in a mobile home, we recommend using a 1/2 inch flex copper connector off of the water heater. From a flex connector to polybutylene, use a Flair-It male adapter. Do not use in a closed loop system. Joints should not be made under concrete. Nuts are included. Flair-It Tee Fitting 1/2 inch x 1/2 inch x 1/2 inch.

Rear Roll Pan Without License Plate for 1992-1998 Chevy Suburban
Carrep Yellow Ignition Lincoln Mercury DG508 FD503
Mix me 4037